Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 503)

Brocade Mobility RFS Controller System Reference Guide 491
53-1003099-01
8
FIGURE 70 Profile Security - Remote VPN Client screen
Set the following Remote VPN Client Configuration settings:
.Refer to the Peer List to select IKEV2 peer configurations and assign them priorities for utilization
with Remote VPN client connections.
IKEv2 uses an initial handshake in which VPN peers negotiate cryptographic algorithms,
mutually authenticate, and establish a session key, creating an IKE-SA. Additionally, a first
IPsec SA is established during the initial SA creation. All IKEv2 messages are
request/response pairs. It is the responsibility of the side sending the request to
retransmit if it does not receive a timely response.
Select OK to save the updates made to the Remote VPN Client screen. Selecting Reset reverts the
screen to its last saved configuration.
Select the Global Settings tab.
The Global Settings screen provides options for Dead Peer Detection (DPD). DPD represents
the actions taken upon the detection of a dead peer within the IPSec VPN tunnel connection.
Shutdown Select this option to shutdown the remote VPN client.
Transform Set Use the drop-down menu to select the transform set configuration to apply to remote client
VPN connections. A transform set is a combination of security protocols, algorithms and
other settings applied to IPSec protected client traffic.