Lenze PLC Designer V2.x - Manual (Page 104)

PLC Designer V2.x| Lenze Application Samples
Working with the sample projects
9400 HighLine - "LAS_40_INTF_Can_94HL_TabPos" sample project
104
L
1.3 EN - 07/2012
8.4.2.1 Open the »Engineer« project & go online

How to open the sample project in the »Engineer«:
1. Start »Engineer«.
2. With the command FileOpen archive, open the LAS_40_INTF_Can_94HL_TabPos
project.
3. Insert the desired motor in the configuration:
– Highlight controller, select the desired motor with the command Insert a component
on the Motors tab
– By clicking Complete, insert the selection in the »Engineer« project.

Detailed infomation on the general handling of the »Engineer« can be found in
the online help for the »Engineer«, which you can call with [F1].