Lenze PLC Designer V2.x - Manual (Page 228)

PLC Designer V2.x| Lenze Application Samples
Adding other components
Copying and inserting nodes of the same series
228
L
1.3 EN - 07/2012
[9-2] Sample project in the »PLC Designer« - node inserted
The activation for the additional node(s) can also be carried out by using the Copy and
Insert commands in the area of the further resources (POUs tab) (as described in the
example for inserting a node of the same series).

Note!
After inserting further nodes, the CAN parameters have to be manually adapted
(node ID and baud rate and further parameters).
• For this, highlight the desired node and carry out the settings on the CAN
parameters tab.
 For instance, you can...
– ...copy a Drive(PRG) program part
– ...insert it below 3_Drive
– ...and then rename it (for instance to
Drive_1(PRG)).