Lenze PLC Designer V2.x - Manual (Page 32)

PLC Designer V2.x| Lenze Application Samples
Commissioning the CANopen Logic bus
Preparing the restart
32
L
1.3 EN - 07/2012
6.3.2 Special features of the 8400 Inverter Drives
Inverter Drives 8400 are purely parameterisable devices.
To put an Inverter Drive 8400 into operation, you can transmit the application using the
»Engineer«. For this, you must keep the original »Engineer« project.
6.3.3 Commission 8200 vector frequency inverters
 Connect the CANopen (E82ZAFUCxxx) fieldbus function module for CAN
communication.
 CAN settings must be made in the »PLC Designer« because the transmission of the
settings to the 8200 vector frequency inverter is carried out from the control system.
6.3.4 Special features of the ECS servo system
 In the ECS servo system, each device has a parameter memory which is only created
once when the parameter setting is created via the »Global Drive Control«. This is the
difference to CANopen devices where the parameterisation is written into the field
device at each system start.
 The EMF2221IB card module serves to read parameters saved on an SD card or
SmartMedia card into every ECS device.
 When using ECS devices, you cannot set all codes/parameters via the Service Data
Objects tab as the EDS files do not contain all codes/parameters.