Lenze PLC Designer V2.x - Manual (Page 185)

1.3 EN - 07/2012
L
185
PLC Designer V2.x| Lenze Application Samples
Working with the sample projects
9300 servo - "LAS_40_INTF_Can_93_Speed" sample project
8.7.6 Interface assignment in the »Global Drive Control«
[8-38] Assignment of digital inputs DIGIN E1 - E5
[8-39] Assignment of the digital outputs: DIGOUT A1 - A4
[8-40] Assignment of the digital inputs: CAN-IN1 - CAN input block
 Terminal 28 (CInh) is to be assigned on
24 V DC.
 The assignment of further digital
inputs is not required.
 The digital outputs A1 and A2 are LOW
active.
 The digital outputs A3 and A4 are HIGH
active.
 The following bits of wCtrl are
assigned and connected to the NSET
block:
bCtrl_B00 = xJog1
bCtrl_B01 = xJog2
bCtrl_B02 = xCCw
bCtrl_B04 = not used
bCtrl_B05 = not used
bCtrl_B06 = freely assignable
bCtrl_B07 = freely assignable
bCtrl_B12 = freely assignable
bCtrl_B13 = freely assignable
bCtrl_B14 = freely assignable
bCtrl_B15 = freely assignable