Lenze PLC Designer V2.x - Manual (Page 13)

PLC Designer V2.x| Lenze Application Samples
About this documentation
13
L
1.3 EN - 07/2012
1 About this documentation
This documentation describes the first commissioning steps of a Lenze automation system
on the basis of a simple example application. The automation system used consists of a PLC
for the control technology and drive components connected (via a bus system).
The explanation of the procedure includes the installation of the integrated development
environment, the »PLC Designer«, and the diagnostics of the application.

Tip!
Information and tools regarding the Lenze products can be found in the download
area under: http://www.Lenze.com
This manual is part of the "PC-based Automation" manual collection. The manual
collection consists of the following parts:

Read the mounting instructions supplied with the controller first before you start
working!
The mounting instructions contain safety instructions which must be observed!

Note!
This documentation supplements the software manuals of the »PLC Designer«
and »Engineer«.
Documentation Subject
System manuals
"PC-based Automation"
• Control technology - System structure & configuration
• Visualisation - System structure & components
Communication manuals
"PC-based Automation"
• CANopen control technology
• PROFIBUS control technology
(Software) manual
"PC-based Automation"
• Industrial PC - Parameter setting & configuration
Operating instructions
"Embedded Line Panel PC"
• EL x8xx - built-in panel PC with TFT display
Operating instructions
"Command Station"
• CS x8xx - stand-alone operator terminal
Operating instructions
"Control Cabinet PC"
• CPC x8xx - control cabinet PC
Operating instructions
"HMI EL 100"
• EL 1xx - HMI with Windows
®
CE
More software manuals • »Global Drive Control« (»GDC«)
–IPC as gateway - Parameter setting & configuration
• »Engineer«
• »PLC Designer« / »PLC Designer - SoftMotion« / »PLC Designer - CANopen
for Runtime Systems«
• »VisiWinNET® Smart«