Lenze PLC Designer V2.x - Manual (Page 85)

1.3 EN - 07/2012
L
85
PLC Designer V2.x| Lenze Application Samples
Working with the sample projects
9400 HighLine - "LAS_40_INTF_Can_94HL_Speed" sample project
8.3.2.1 Open the »Engineer« project & go online

How to open the sample project in the »Engineer«:
1. Start »Engineer«.
2. Use the command FileArchiveOpen to open the project
"LAS_40_INTF_Can_94HL_Speed".
3. Insert the desired motor in the configuration:
– Highlight controller, select the desired motor with the command Insert a component
on the Motors tab
– By clicking Complete, insert the selection in the »Engineer« project.

Detailed infomation on the general handling of the »Engineer« can be found in
the online help for the »Engineer«, which you can call with [F1].