Lenze PLC Designer V2.x - Manual (Page 148)

PLC Designer V2.x| Lenze Application Samples
Working with the sample projects
8200 vector - "LAS_40_INTF_Can_82_Speed" sample project
148
L
1.3 EN - 07/2012
8.6 8200 vector - "LAS_40_INTF_Can_82_Speed" sample project
Further information on the function libraries used in this project can be found in
the following section:
 The L_S8V_Drive82Vector.lib library
( 267)
Standard procedure

How to commission the controller:
1. Commission 8200 vector.  Commissioning
( 149)
2. Load the project "LAS_40_INTF_Can_82Speed.gdc" to the controller using the L-
force »Global Drive Control«.

Open the »Global Drive Control« project & go
online
( 149)
3. Open the "LAS_40_INTF_Can_82_Speed.pro" sample project in the »PLC
Designer«.  Program structure in the »PLC Designer«
( 152)
4. Load the project to the IPC/EL 1xx and go online.
8.6.1 Components used
[8-31] System configuration with EL x800 CAN master (ID=0, connection at CAN 1) and 8200 vector (CAN node ID=5)
Industrial PC Field device
Hardware EL x800 8200 vector (82S8212V_37000)
Operating system IPC software from version Logic
7.04.x (release 2.2.x)
From firmware V3.7
Lenze software required »PLC Designer« from version 2.3
»Global Drive Control« from version
4.11
Further requirements • CAN master ID = 0
• Connection to interface CAN 1
• Logic CAN 500kB
• CAN module CAN PT/
E82ZAFCC010
• CAN node ID = 5
• Motor: MDEMA 071-32