Lenze PLC Designer V2.x - Manual (Page 213)

1.3 EN - 07/2012
L
213
PLC Designer V2.x| Lenze Application Samples
Working with the sample projects
ECS/9400/8400 - "LAS_40_INTF_84SL_Speed_94HL_Speed_ECSPosShaft" sample project
8.9.2 Short overview of the functions
ECS xP
9400 HighLine / 8400 StateLine
8.9.2.1 Commissioning
ECS xP
 Commissioning
( 126)
 Open the »Global Drive Control« project & go online ( 127)
9400 HighLine

Open the »Engineer« project & go online
( 85)
8400 StateLine

Open the »Engineer« project & go online
( 43)
Mode Description
Automatic In the automatic mode a sequence runs over an infinite loop.
Selection:
When the drive is referenced...
1.Travel to Position 1,
2.Travel to Position 2,
3.Start at (1.) again.
Manual In manual mode, the controller can be actuated by setting the individual
control bits manually (Jog1, Jog2, QSP, ErrorReset...). Like this, the controller
can be actuated in manual mode, for instance for cleaning or changing the
tools.
Service The service mode serves to adjust the controller.
Selection:
• Travel in positive direction for one second,
• Stop for one second,
• Travel in negative direction for one second.
Homing In the homing mode the drive is referenced.
• Either the home position is set directly, or a homing is started.
Mode Description
Automatic In the automatic mode a sequence runs over an infinite loop.
Selection:
• Travel for three seconds at speed1,
• then for five seconds at speed2,
• Start with speed1 again.
Manual In manual mode, the controller can be actuated by setting the individual
control bits manually (Jog1, Jog2, QSP, ErrorReset...). Like this, the controller
can be actuated in manual mode, for instance for cleaning or changing the
tools.
Service The service mode serves to adjust the controller.
Selection:
• Travel in positive direction for one second,
• Stop for one second,
• Travel in negative direction for one second.