Lenze PLC Designer V2.x - Manual (Page 225)

1.3 EN - 07/2012
L
225
PLC Designer V2.x| Lenze Application Samples
Working with the sample projects
ECS/9400/8400 - "LAS_40_INTF_84SL_Speed_94HL_Speed_ECSPosShaft" sample project
8.9.3.7 CAN diagnostics
The CanDiagnostic button selects the diagnostics of the CAN bus.
 The mode selected last remains active.
 This area shows the status of the master and slaves, which are integrated in the control
configuration.
8.9.4 Interface assignment in the device
The assignment of the device interfaces in the multiproject are identical to those of the
respective device project.
ECS
– Further information on the assignment of the ECS interfaces can be found in the
following section:  Interface assignment in the device
( 146)
9400 HighLine
– Further information on the assignment of the 9400 HighLine interfaces can be found
in the following section:  Interface assignment in the »Engineer«
( 100)
8400 StateLine
 Status of the CAN master (node ID )
 Status of the CAN slaves