Lenze PLC Designer V2.x - Manual (Page 15)

PLC Designer V2.x| Lenze Application Samples
About this documentation
15
L
1.3 EN - 07/2012
Further technical documentation on Lenze components
More information on Lenze components that can be used together with "PC-based
automation" can be found in the following documentation:
Target group
The documentation addresses to persons who plan, install, commission, and maintain the
networking of devices in the field of control technology.
Mounting & wiring Legend:
 MAs for Inverter Drives 8400  Printed documentation
 MAs for Servo Drives 9400  Online help/PDF
 MA EPM-Txxx (I/O system IP20) Abbreviations used:
 MA EPM-Sxxx (I/O system 1000) SHB System manual
 MA 8200 vector BA Operating instructions
 8200 vector wiring according to EMC MA Mounting instructions
 MAs for the ECS servo system SW Software manual
 MA MC-CAN2 communication card KHB Communication manual
 MA MC-ETC communication card
 MA MC-ETH communication card
 MA MC-PBM communication card
 MA MC-PBS communication card
 MA MC-MPI communication card
 MAs for communication modules
Parameterisation, configuration, commissioning

SW Inverter Drives 8400
BaseLine / StateLine / HighLine / TopLine
Í This documentation contains further
information when using the sample projects
 SW Servo Drive 9400 HighLine / PLC Í This documentation contains further
information when using the sample projects
 9400 HighLine commissioning guidelines
 SHB I/O system IP20 (EPM-Txxx)
 SHB I/O system 1000 (EPM-Sxxx)
 SHB 8200 vector Í This documentation contains further
information when using the sample projects
 BAs for the ECS servo system Í This documentation contains further
information when using the sample projects
 KHBs for the communication modules
Programming

SW 9400 function library
Establishing a network

KHBs for the communication modules