Lenze PLC Designer V2.x - Manual (Page 28)

PLC Designer V2.x| Lenze Application Samples
Commissioning the CANopen Logic bus
Commissioning field devices
28
L
1.3 EN - 07/2012
6.2 Commissioning field devices
Parameterise the field devices connected to the CANopen Logic bus either with the
»Engineer« or with the »GDC«, depending on the device.
The configuration of the CAN parameters takes place in the »PLC Designer«.

Tip!
We recommend to commission each field device individually and then open the
suitable PLC program.

For this, observe the information in the ...
• documentation for the field devices;
• documentation for the »Engineer« / »GDC«, and »PLC Designer«.