Lenze PLC Designer V2.x - Manual (Page 193)

1.3 EN - 07/2012
L
193
PLC Designer V2.x| Lenze Application Samples
Working with the sample projects
9300 - "LAS_40_INTF_Can_93_EP" sample project
8.8.4 Program structure in the »PLC Designer«

How to proceed:
1. In the »PLC Designer«, open the "LAS_40_INTF_Can_93_EP.pro" sample project.
2. Load the project to the IPC and Go online.
8.8.4.1 Control configuration
 The CAN master (ID = 0) is the control section of the system configuration
 Below the CAN master the 9300 EP (CAN node ID = 5) is attached.
– The 9300 EP is embedded in the form of a device-independent EDS file
(LenzeDrive_Can1_4Word).
 One PDO each is used for CAN-Input and CAN-Output.
 The transmission mode is sync-controlled (10 ms).