7 parameter setting, 1 general information, Parameter setting – Lenze ECSCAxxx User Manual
Page 148: General information
Parameter setting
General information
7
l
148
EDBCSXA064 EN 3.2
7
Parameter setting
7.1
General information
ƒ
Controllers and power supply modules can be adapted to your application by setting
the parameters. A detailed description of the functions can be found in the chapter
"Commissioning" (
¶ 102).
ƒ
The parameters for the functions are stored in numbered codes:
– The codes are marked in the text with a "C".
– The code table in the appendix (
¶ 384) provides a quick overview of all codes. The
codes are sorted in numerical ascending order, thus serving as a "reference book".
Parameter setting with XT keypad or PC/laptop
Detailed information on parameter setting with the XT keypad can be found in the
following chapters.
,
Detailed information ...
on the parameterisation by means of a PC/laptop can be found in the
documentation for the "Global Drive Control" (GDC) parameterisation and
operating program.
In addition to parameter setting, the XT keypad or PC/laptop serves to:
ƒ
Control the controller (e. g. inhibiting or enabling)
ƒ
Select the setpoints
ƒ
Display operating data
ƒ
Transfer parameter sets to other controllers (only with PC/laptop).
Parameter setting with a bus system
,
Detailed information ...
on the parameterisation with a bus system can be found in the
documentation of the communication module to be applied (
¶ 461).