Rockwell Automation 284 ArmorStart User Manual - Manual (Page 145)

Bulletin 284 Programmable Parameters for Volts per Hertz Controllers 5-23
Drvin DNFltState
This parameter, in conjunction with Parameter 52, defines how the Drive Digital
Inputs 1…2 will respond when a DeviceNet fault occurs. When set to 1, Drive
Digital Inputs 1…2 hold last state occurs. When set to 0, will go to DnFlt Value on
DN faults as determined by Parameter 52.
0 = Go to Fault Value
1 = Hold Last State Parameter Number 51
Access Rule GET/SET
Data Type BOOL
Group Drive DeviceNet
Units —
Minimum Value 0
Maximum Value 1
Default Value 0
Drvin DNFlt Value
This parameter determines if the drive will be commanded in the event of a
DeviceNet fault.
0 = OFF
1 = ON Parameter Number 52
Access Rule GET/SET
Data Type BOOL
Group Drive DeviceNet
Units —
Minimum Value 0
Maximum Value 1
Default Value 0
Drvin DNIdlState
This parameter, in conjunction with Parameter 54, defines how the Drive Digital
Input 1…2 will respond when a DeviceNet network is idle. When set to 1, hold to
last state occurs. When set to 0, will go to DnFlt Value on DN faults as determined
by Parameter 54.
0 = Go to Fault Value
1 = Hold Last State
Parameter Number 53
Access Rule GET/SET
Data Type BOOL
Group Drive DeviceNet
Units —
Minimum Value 0
Maximum Value 1
Default Value 0
StrtrDN IdlValue
This parameter determines the state that Digital Inputs 1…2 assume when the
network is idle and Parameter 53 is set to 0.
0 = OFF
1 = ON
Parameter Number 54
Access Rule GET/SET
Data Type BOOL
Group Drive DeviceNet
Units —
Minimum Value 0
Maximum Value 1
Default Value 0