Rockwell Automation 284 ArmorStart User Manual - Manual (Page 91)

Chapter
4
Bulletin 283 Programmable Parameters
Introduction This chapter describes each programmable parameter and its
function.
Parameter Programming
Each Distributed Motor Controller type will have a common set of
parameters followed by a set of parameters that pertain to the
individual starter type.
Refer to Chapter 8, DeviceNet™ Commissioning for instructions in
using RSNetWorx™ for DeviceNet™ to modify parameter settings.
Refer to Chapter 11, ArmorStart® to ArmorPoint® Connectivity for
instructions to modify parameter settings when using the Bulletin
283A with the ArmorPoint® distributed I/O products.
Important: Resetting the Factory Default Values Parameter 47,
Set to Defaults, allows the installer to reset all parameters
to the factory default values. It also resets the MAC ID to
its factory default after DeviceNet Power is cycled if
switches are set >63.
Important: Parameter setting changes downloaded to the
ArmorStart® take effect immediately, even during a
“running” status.
Important: Parameter setting changes made in a configuration tool
such as RSNetWorx for DeviceNet do not take effect in
the ArmorStart until the installer applies or downloads
the new settings to the device.