Rockwell Automation 284 ArmorStart User Manual - Manual (Page 351)

Bulletin 280/281 CIP Information B-7
Table B.17 Instance 185 This is a “Read Only” Status Assembly
Table B.18 Instance 186 This is a “Read Only” Status Assembly
Table B.19 Instance 187 This is a “Read/Write” Assembly
Table B.20 Instance 189 This is a “Read-Only” Assembly
➊ Reserved for 280A/281A
Standard Distributed Motor
Controller I/O Assemblies Standard Distributed Motor Controller IO Assemblies are available
on all Starter Types.
Standard Distributed Motor Controller Output (Consumed)
Assemblies
Table B.21 Instance 3 is the required output (consumed) assembly defined in
the DeviceNet Motor Starter Profile
Instance 185 — Starter Status
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 At Ref —
Net Ctl
Status
Ready
Running
Rev
Running
Fwd
Warning Tripped
1 — — 140M On
HOA
Stat.
Keypad
Hand
— — —
Instance 186 — DeviceNet Status
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 — — — I/O Idle I/O Flt Exp Flt I/O Cnxn Exp Cnxn
1 ZIP FLT ZIP4 CNX ZIP3 FLT ZIP2 CNX ZIP2 FLT ZIP2 CNX ZIP1 FLT ZIP1 CNX
Instance 187 — Starter Control Bits
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0
User Out
B
User Out
A
— — —
Fault
Reset
Run Rev Run Fwd
1 — — — — — — — —
Instance 189 — Warning Status Bits
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 —
IO
Warning
Control
Power
Warning
— —
PL
Warning
— —
1 — — HW Warn — — —
DN
Warn ➊
PI Warn
Instance 3 — ODVA Starter
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 — — — — — — — Run Fwd