Rockwell Automation 284 ArmorStart User Manual - Manual (Page 197)

Bulletin 284 Programmable Parameters for Sensorless Vector Controllers 6-23
Drive Status
Present operating condition of the drive.
Bit 0 = running
Bit 1 = Forward
Bit 2 = Accelerating
Bit 3 = Decelerating Parameter Number 106
Related Parameter 195
Access Rule GET
Data Type Byte
Group Display Group
Units —
Minimum Value 0
Maximum Value 1
Default Value Read Only
Fault 1 Code
A code that represents drive fault. The code will appear in this parameter as the
most recent fault that has occurred. Parameter Number 107
Access Rule GET
Data Type UINT
Group Display Group
Units —
Minimum Value F122
Maximum Value F2
Default Value Read Only
Fault 2 Code
A code that represents a drive fault. The code will appear in this parameter as the
second most recent fault that has occurred. Parameter Number 108
Access Rule GET
Data Type UINT
Group Display Group
Units —
Minimum Value F122
Maximum Value F2
Default Value Read Only
Fault 3 Code
A code that represents a drive fault. The code will appear in this parameter as the
third most recent fault that has occurred. Parameter Number 109
Access Rule GET
Data Type UINT
Group Display Group
Units —
Minimum Value F122
Maximum Value F2
Default Value Read Only
Process Display
The output frequency scaled by the process factor (Parameter 199). Parameter Number 110
Related Parameter 101. 199
Access Rule GET
Data Type LINT
Group Display Group
Units 0.01…1
Minimum Value 0.00
Maximum Value 9999
Default Value Read Only