Rockwell Automation 284 ArmorStart User Manual - Manual (Page 98)

4-8 Bulletin 283 Programmable Parameters
Starter Command
The parameter provides the
status of the starter command.
Parameter Number 7
Access Rule GET
Data Type WORD
Group DeviceLogix
Units —
Minimum Value 0
Maximum Value 255
Default Value 0
Bit
Function:
7 6 5 4 3 2 1 0
— — — — — — — X Run Fwd
— — — — — — X — Reserved
— — — — — X — — Fault Reset
— — — — X — — — Reserved
— — — X — — — — Reserved
— — X — — — — — Reserved
— X — — — — — — User Out A
X — — — — — — — User OUt B
Network Override
This parameter allows for the
local logic to override a Network
fault
0 = Disable
1 = Enable
Parameter Number 8
Access Rule GET/SET
Data Type BOOL
Group DeviceLogix
Units —
Minimum Value 0
Maximum Value 1
Default Value 0
Comm Override
This parameter allows for local
logic to override the absence of
an I/O connection
0 = Disable
1 = Enable
Parameter Number 9
Access Rule GET/SET
Data Type BOOL
Group DeviceLogix
Units —
Minimum Value 0
Maximum Value 1
Default Value 0