Rockwell Automation 284 ArmorStart User Manual - Manual (Page 149)

Bulletin 284 Programmable Parameters for Volts per Hertz Controllers 5-27
Zone #1 Offset
The byte offset into the ZIP data portion of the DeviceLogix data table to place the
chosen consumed data bytes for zone 1.
Parameter Number 82
Access Rule GET/SET
Data Type UINT
Group ZIP Parameters
Units —
Minimum Value 0
Maximum Value 7
Default Value 0
Zone #2 Offset
The byte offset into the ZIP data portion of the DeviceLogix data table to place the
chosen consumed data bytes for zone 2.
Parameter Number 83
Access Rule GET/SET
Data Type UNIT
Group ZIP Parameters
Units —
Minimum Value 0
Maximum Value 7
Default Value 0
Zone #3 Offset
The byte offset into the ZIP data portion of the DeviceLogix data table to place the
chosen consumed data bytes for zone 3.
Parameter Number 84
Access Rule GET/SET
Data Type UNIT
Group ZIP Parameters
Units —
Minimum Value 0
Maximum Value 1
Default Value 0
Zone #4 Offset
The byte offset into the ZIP data portion of the DeviceLogix data table to place the
chosen consumed data bytes for zone 4.
Parameter Number 85
Access Rule GET/SET
Data Type UNIT
Group ZIP Parameters
Units —
Minimum Value 0
Maximum Value 1
Default Value 0
Zone #1 EPR
The Expected Packet Rate in msec. for the zone 1 consuming connection. If
consumed data is not received in 4 times this value, the zone connection will time
out and “Zone #1 Health” will report 1 = Not Healthy.
Parameter Number 86
Access Rule GET/SET
Data Type UINT
Group ZIP Parameters
Units msec
Minimum Value 0
Maximum Value 65535
Default Value 75