Rockwell Automation 284 ArmorStart User Manual - Manual (Page 446)

G-2 Accessories
Table G.2 Sensor Media ➊
➊ See Publication M116-CA001A-EN-P for complete cable selection information.
➋ Replace symbol with desired length in meters (Example: 889D-F4ACDM-1 for a 1 m cable). Standard cable lengths: 1 m, 2 m, 5 m, and 10 m.
Table G.3 Sealing Caps
➌ To achieve IP 67 rating, sealing caps must be installed on all unused I/O connections.
➍ To achieve IP 69k/NEMA 4X rating, sealing caps must be installed on all unused I/O connections.
Table G.4 ArmorPoint® Media
Table G.5 Locking Clips
Description
ArmorStart® I/O
Connection
Pin Count Connector Cat. No.
0
0
Input 5-Pin
Straight Female
Straight Male
889D-F4ACDM-
➋
Straight Female
Right Angle Male
889D-F4AACDE-
➋
0
0
Input 5-pin
Straight Female 879D-F4ACDM-
➋
Right Angle Male 879D-R4ACM-
➋
Output 3-pin
Straight Female
Straight Male
889R-F3AERM-
➋
Straight Female
Right Angle Male
899R-F3AERE-
➋
Description For Use With Cat. No.
Plastic Sealing Cap (M12) ➌ Input I/O Connection 1485A-M12
Aluminum Sealing Cap (M12) ➌ Output I/O Connection 889A-RMCAP
Stainless Steel Sealing Cap (M12)
➍ Input I/O Connection 1485AS-C3
Stainless Steel Sealing Cap (M12)
➍ Output I/O Connection 889AS-RMCAP
Description Length Cat. No.
ArmorPoint Bus Extension Cable including Terminating Resistor 1 m (3.3 ft) 280A-EXT1
Extension Cable to connect two ArmorStart Distributed Motor
Controllers to ArmorPoint communication protocol
1 m (3.3 ft) 280A-EXTCABLE
Description Package QTY Cat. No.
The clam shell design clips over the ArmorStart motor connector and motor cable to limit customer
access. 10 280-MTR22-LC
10 280-MTR35-LC
DC Micro Patchcord
DC Micro V-Cable
AC Micro Patchcord