Rockwell Automation 284 ArmorStart User Manual - Manual (Page 64)

3-2 Bulletin 280/281 Programmable Parameters
Parameter Group Listing The Bulletin 280/281 ArmorStart contains eight parameter groups.
The parameters shown in the DeviceLogix, DeviceNet, Starter
Protection, User I/O, Misc. Parameter, ZIP Parameters, Starter
Display and Starter Setup, are discussed in this chapter.
Table 3.1 Parameter Group Listing
DeviceLogix™ Group
DeviceLogix DeviceNet
Starter
Protection
User I/O Misc. ZIP Parameters Starter Display Starter Setup
1 Hdw Inputs 10 Autobaud Enable 22 Breaker Type 30 Off-to-On Delay 45 Keypad Mode 67 AutoRun Zip 101 Phase A Current 106 FLA Setting
2 Network Inputs 11 Consumed IO Assy 23 PrFltResetMode 31 On-to-Off Delay 46 Keypad Disable 68 Zone Produced EPR 102 Phase B Current 107 Overload Class
3 Network Outputs 12 Produced IO Assy 24 Pr Fault Enable 32 In Sink/Source 47 Set To Defaults 69 Zone Produced PIT 103 Phase C Current 108 OL Reset Level
4 Trip Status 13 Prod Assy Word 0 25 Pr Fault Reset 33 OutA Pr FltState 56 Base Enclosure 70 Zone #1 MacId 104 Average Current
5 Starter Status 14 Prod Assy Word 1 26 StrtrDN FltState 34 OutA Pr FltValue 57 Base Option 71 Zone #2 MacId 105% Therm Utilized
6 DNet Status 15 Prod Assy Word 2 27 StrtrDN FltValue 35 OutA DN FltState 58 Wiring Option 72 Zone #3 MacId
7 Starter Command 16 Prod Assy Word 3 28 StrtrDN IdlState 36 OutA DN FltValue 59 Starter Enclosure 73 Zone #4 MacId
8 Network Override 17 Consumed IO Size 29 StrtrDN IdlValue 37 OutA DN IdlState 60 Starter Options 74 Zone #1 Health
9 Comm Override 18 Produced IO Size 61 Last PR Fault 38 OutA DN IdlValue 75 Zone #2 Health
19 Starter COS Mask 62 Warning Status 39 OutB Pr FltState 76 Zone #3 Health
20 Net Out COS Mask 40 OutB Pr FltValue 77 Zone #4 Health
21 DNet Voltage 41 OutB DN FltState 78 Zone #1 Mask
42 OutB DN FltValue 79 Zone #2 Mask
43 OutB DN IdlState 80 Zone #3 Mask
44 OutB DN IdlValue 81 Zone #4 Mask
82 Zone #1 Offset
83 Zone #2 Offset
84 Zone #3 Offset
85 Zone #4 Offset
86 Zone #1 EPR
87 Zone #2 EPR
88 Zone #3 EPR
89 Zone #4 EPR
90 Zone #1 Control
91 Zone #2 Control
92 Zone #3 Control
93 Zone #4 Control
94 Zone #1 Key
95 Zone #2 Key
96 Zone #3 Key
97 Zone #4 Key
98 Device Value Key
99 Zone Ctrl Enable
Hdw Inputs
This parameter provides status of
hardware inputs
Parameter Number 1 ➊
Access Rule GET
Data Type WORD
Group DeviceLogix
Units —
Minimum Value 0
Maximum Value 15
Default Value 0