Rockwell Automation 284 ArmorStart User Manual - Manual (Page 237)

Chapter
7
HOA Keypad Operation
Introduction This chapter provides a basic understanding of the programming of
the factory-installed optional built-in Hand/Off/Auto (HOA) keypad.
The HOA keypad can be programmed for maintained or momentary
operation.
Figure 7.1 Optional HOA Keypads
Keypad Description The keys found on the optional HOA keypads are described below:
Table 7.1 HOA Keypad — Key Description
Available on Bulletin 281 Available on Bulletin 284 Available on
Bulletin 280/281
or Bulletin 283
HAND The Hand key will initiate starter operation
AUTO
The Auto key allows for Start/Stop control via the
communications network
OFF
If the starter is running, pressing the OFF key will
cause the starter to stop.
REV The REV key selects reverse direction of the motor
FWD The FWD key selects forward direction of the motor
DIR Arrow
The Dir arrow selects the direction of the motor, either
forward or reverse.
JOG
When pressed, JOG will be initiated if no other control
devices are sending a stop command. Releasing the
key will cause the drive to stop, using selected stop
mode.