Teac GigaStudio 4 - Manual (Page 118)

GigaStudio 4 Reference Manual 118
Fader
The fader controls the channel strip’s audio level. It is visible in both wide and narrow mode. To “fine-tune”
the level you can hold down the shift key while moving the fader.
•
The meter (A) to the right of the fader indicates signal level. If the top red clip indicators light, reduce the
fader level.
• The numeric fields directly below the fader and above the Link/Unlink buttons (B) show the amount of
fader attenuation.
• The fader can control the left and right channel levels simultaneously (link mode), or control the left and
right channel levels independently (unlink mode). Select the mode using the Link/Unlink button toward
the bottom of the fader. Note that you cannot Unlink, set a level offset, then Re-link and retain the level
offset. If there is an offset, upon Re-linking the fader will jump to the higher of the two channel values.
Position/Pan Controls
GigaStudio 4 offers more flexible panning options than most mixers—hardware or software. These are set by
the two knobs located above the channel strip fader, visible in both wide and narrow mode. The numeric field
below each control indicates the direction of the panning (R = right, L = left) and the amount of panning (from
L100 to R100, C if centered).