Canon imageCLASS MF264dw II Multifunction Monochrome Laser Printer - Manual (Page 632)

Cannot Access Remote UI or Send Function Setting Tool
8W0J-0H7
If the message [Cannot access Remote UI.] or [Cannot continue the settings because the function to perform settings
for the device is restricted.] appears and you cannot access Remote UI or Send Function Setting Tool, troubleshoot by
checking the items below.
Set the Remote UI Access PIN.
To access the Remote UI and Send Function Setting Tool, you must set the Remote UI Access PIN.
Administrator privileges are required to configure the setting.
Touch Panel Model
[Home] screen on the control panel [Menu] [Management Settings] [Remote UI Settings/Update
Firmware] [Remote UI Settings] [Remote UI Access Security Settings] [On] enter the PIN [Apply]
enter the PIN again [Apply]
5 Lines LCD Model
on the control panel [Management Settings] [Remote UI Settings/Update
Firmware] [Remote UI Settings] [Remote UI Access Security Settings]
[On] enter the PIN enter the PIN again
* You cannot set a PIN consisting of all zeros, such as "00" or "0000000."
Change the System Manager PIN.
When logging in with System Manager Mode, you must change the System Manager PIN from the default
settings.
Administrator privileges are required to change the settings.
Touch Panel Model
[Home] screen on the control panel [Menu] [Management Settings] [User Management] [System
Manager Information Settings] [System Manager ID and PIN] enter the System Manager ID [Apply]
enter the PIN [Apply] enter the PIN again [Apply]
5 Lines LCD Model
on the control panel [Management Settings] [User Management] [System
Manager Information Settings] [System Manager ID and PIN] enter the System
Manager ID enter the PIN enter the PIN again
* You cannot set a System Manager ID or PIN consisting of all zeros, such as "00" or "0000000."
* Only allow certain administrators to have access to the System Manager ID and PIN after the settings are
changed.
Troubleshooting
623