Canon imageCLASS MF264dw II Multifunction Monochrome Laser Printer User Manual
Page 80
2
Select the SSID of the wireless LAN to which you want to connect, and press
.
➠
The Network Key input screen is displayed.
When selecting the SSID of the wireless LAN router supporting WPA-EAP or WPA2-EAP for the security
standard, the message [IEEE 802.1X Settings values will be applied to connect.] appears. Select [OK] and
press
, and proceed to Step 4.
If you cannot find the wireless LAN router to which you want to connect, check that the router is
discoverable. Cannot Connect to Wireless LAN(P. 591)
3
Enter the network key, and press [<Apply>]
.
4
Check the message, and select [Yes]
.
5
When [Connected.] is displayed on the control panel, wait a few minutes.
➠
When the machine is connected to the wireless LAN, [
] appears on the [Home] screen.
By default, an IP address is set automatically.
To use a specific IP address, set this manually.
Setting IPv4 Addresses(P. 77)
Setting IPv6 Addresses(P. 81)
If an Error Message Appears during Operation and a Connection Cannot Be Established
●
Select [Close] and press
, check the information (SSID or network key) of the wireless LAN router to
which you want to connect, and repeat the procedure starting from Step 2.
Setting Up
71