Canon imageCLASS MF264dw II Multifunction Monochrome Laser Printer - Manual (Page 639)

Cannot change the destination type of any destination that is registered to a
group.
The selected destination is registered to a group, so you cannot change the destination type.
Delete the Destination from the Group, Change the Destination Type, and Then Register It to the
Group Again.
1
Delete the destination from the group.
Deleting Using Remote UI
Log in to Remote UI in System Manager Mode [Address Book] [One-Touch] or [Coded Dial] select
the group to which the destination is registered [Edit] select the destination [Delete] [OK]
Deleting Using the Control Panel
[Home] screen on the control panel [Addr. Book] [Details/Edit] select the group to which the
destination is registered [Edit] [Number of Destinations] select the destination [Remove]
[Yes] [Apply] [Apply]
2
Change the destination type.
Registering Destinations to the Address Book (Remote UI)(P. 176)
Editing and Deleting Destinations in the Address Book (Control Panel)(P. 175)
3
Register the destination to the group again.
Registering Groups to the Address Book (Remote UI)(P. 180)
Registering Groups to the Address Book (Control Panel)(P. 173)
Cannot find the access point.
An error occurred, preventing the machine from detecting the wireless LAN router (access point).
Is Connection Type Configured Correctly?
Select the connection type (WPS) according to the method supported by the wireless LAN router.
Connecting to a Wireless LAN by Using the Router Button (Push Button Mode)(P. 64)
Did You Connect Within the Fixed Time?
When connecting by pressing a button on the wireless LAN router, set the connection type on the control
panel of the machine, and then press the button on the wireless LAN router within one or two minutes.
Connecting to a Wireless LAN by Using the Router Button (Push Button Mode)(P. 64)
Are the SSID and Network Key Configured Correctly?
When entering the wireless LAN router information manually, check the SSID and network key of the wireless
LAN router, and configure the settings correctly on the machine. Connecting to a Wireless LAN by
Setting the Details (Manual Setup Method)(P. 72)
Are the Machine and Wireless LAN Router Located Appropriately?
● The machine and wireless LAN router should be installed in a location without walls or other obstructions
between the devices and within range of 164' (50 m).
● Do not install near a microwave oven, digital cordless telephone, or other device that generates radio
waves.
Troubleshooting
630