Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 1004)

952 Brocade Network Advisor IP User Manual
53-1003153-01
VLAN Manager
28
Displaying a list of VLANs
To view the list of VLANs that were discovered on the network, select Configure > VLANs.
The VLAN View tab of the VLAN Manager dialog box displays.
The VLAN Manager tool bar contains the following buttons:
• Add — Launches the Add VLAN dialog box.
• Edit — Launches the Edit VLAN dialog box.
• Delete — Launches the Delete VLAN dialog box.
• STP — Allows you to configure STP, RSTP, MSTP, PVST, or RPVST information for a product, port,
or VLAN.
• ACL — Launches the ACL Configuration dialog box, where you can assign access control lists to
a VLAN.
• 802.1ag CFM — If the Management application manages at least one of the service provider
products (NetIron XMR, MLX, CES, or CER), this button launches the 802.1ag CFM
configuration dialog box.
• Virtual Port IP — Launches the IP Address dialog box, which allows you to add an IP address to
a Switch Virtual Interface (SVI) on DCB products (also known as a Virtual Routing Interface).
• Deployments — Launches the Deploy VLANs dialog box and displays only saved VLAN and STP
deployments.
• Manage — Launches the Manage VCS Virtual Fabric dialog box (refer to “Enabling or disabling
the VCS Virtual Fabric mode” ).
VLAN management in a VCS environment
Table 91 lists the VLAN management features that are supported in VCS mode (Fabric mode),
logical chassis mode, and standalone mode.
TABLE 91 VLAN management features supported for VCS mode
Feature VCS (FC mode) Logical chassis mode Standalone mode
VLAN topology Yes (shown at the fabric level) Yes Yes
STP topology No No Yes
VLAN Manager Yes (shown at the fabric level) Yes Yes
STP views No No Yes
VLAN reports Yes Yes Yes
STP reports No No Yes