Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 1120)

1068 Brocade Network Advisor IP User Manual
53-1003153-01
Controller configuration
31
FIGURE 450 Controller Configuration dialog box
1. Enter a name for the configuration in the Configuration Name field. The combination of a GSLB
controller name and the Management application user who created the definition must be
unique.
2. Select the ServerIron ADX product from the Controller list that will be the GSLB controller.
3. Select the controller policy from the Controller Policy list that will be deployed to the controller.
The list comes from the list on the Policy Configuration tab.
4. Enter the GSLB Communication Port number that the controller ServerIron ADX product will
use for the GSLB protocol in the GSLB Communication Port field. This parameter setting is
deployed to the controller and to site ServerIron ADX products specified in this configuration.
5. Select the Reload on Deployment check box if you want the ServerIron ADX product to perform
a software reload when this configuration is deployed to the selected products.
6. Select the Enable Logging check box if you want to enable logging of the following information
for DNS requests assisted by the GSLB ServerIron ADX product:
• Source IP address (the address of the client making the request)
• Best IP address (site address provided by the ServerIron ADX product)
• Host
• Zone
• Metric used
This parameter setting is deployed to the controller and to the site ServerIron ADX products
specified in this configuration. When you enable logging of this information, the ServerIron ADX
product generates a syslog message for each DNS request assisted by the ServerIron ADX
product.