Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 777)

Brocade Network Advisor IP User Manual 725
53-1003153-01
Layer 3 access control list policy
19
3. Click Yes on the confirmation message.
4. Click Close on the Network dialog box.
To finish configuring the ACL, return to one of the above procedures.
Network group configuration
The Management application allows you to filter traffic from a specific network group. A network
group is made up of one or more devices, networks, or network groups. Use the following
procedures to configure a network:
• “Viewing existing network groups” on page 725
• “Creating a network group” on page 726
• “Editing a network group” on page 727
• “Copying a network group” on page 728
• “Deleting a network group” on page 730
Viewing existing network groups
You can access the Network dialog box when configuring a standard or extended L3 ACL device
configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:
• “Creating a standard L3 ACL configuration” on page 700
• “Editing a standard L3 ACL configuration” on page 702
• “Copying a standard L3 ACL configuration” on page 703
• “Creating an extended L3 ACL configuration” on page 704
• “Editing an extended L3 ACL configuration” on page 706
• “Copying an extended L3 ACL configuration” on page 707
To view all existing network groups, complete the following steps.
1. Click the Network Group tab.
FIGURE 284 Network dialog box, Network Group tab