Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 1318)

1266 Brocade Network Advisor IP User Manual
53-1003153-01
Running a configuration policy manager
37
Running a configuration policy manager
Before you run a configuration policy manager, make sure your configuration policy managers are
valid. Valid configuration policy managers must have at least one policy selected with one or more
targets. Management checks do not require a target.
To run an existing configuration policy manager, complete the following steps.
1. Select Monitor > Configuration Policy Manager.
The Configuration Policy Manager dialog box displays.
2. Select the policy you want to run in the Monitors list.
3. Click Run.
When the configuration policy manager check is complete, the Policy_Name - Configuration
Policy Manager Report displays (
Figure 533 ) in a web browser.
FIGURE 533 Policy_Name - Configuration Policy Manager Report
4. Review the report details (refer to “Viewing a configuration policy manager report” on
page 1267).
To export a report, refer to “Exporting a configuration policy manager report” on page 1270.
To e-mail a report, refer to “Exporting IP reports to e-mail recipients” on page 1365.
5. Click the close button (X) on the Policy_Name - Configuration Policy Manager Report browser
window.
6. Click Close on the Configuration Policy Manager dialog box.