Brocade Network Advisor IP User Manual v12.3.0 User Manual
Page 1291
Brocade Network Advisor IP User Manual
1239
53-1003153-01
Adding a configuration policy manager
37
a. Select the Check zoning status check box to determine if zoning is enabled or disabled on
the fabric.
•
Select the Enabled option to determine if zoning is enabled.
•
Select the Disabled option to determine if zoning is disabled.
For more information about this check and a fix for rule violations, refer to
b. Select the Check that all zones belong to at least one zone config check box to determine
if there are orphaned zones in the fabric zone database.
For more information about this check and a fix for rule violations, refer to
c. Select the Check the number of initiator ports zoned to each storage port check box to
determine the total number of initiator ports zoned to each storage port.
For more information about this check and a fix for rule violations, refer to
d. Select the Check zones that do not contain any online member check box to identify zones
in which all zone members are offline.
For more information about this check and a fix for rule violations, refer to
e. Enter the initiator port limit in the Initiator Port Limit field.
The default recommended threshold ratio is 1:1 (1 initiator port to 1 target port).
Therefore, if the ratio for the storage port is equal to or higher than 1:1, the configuration
policy manager considers it as a violation and logs it in the report.
f.
Select the Check that all profiles are the same on each RBridge in an Ethernet fabric
check box to determine if all RBridge profiles in an Ethernet fabric are the same.
For more information about this check and a fix for rule violations, refer to
g. Select the fabrics to which you want to apply this policy in the Available Fabrics list and
click the right arrow button.
NOTE
You can use the All Fabrics target in the Available Fabrics list for future provisioning. Select
All Fabrics and click the right arrow button to apply this policy to all discovered fabrics.
The selected fabrics display in the Selected Fabrics list.
7. To set configuration policy managers for switches, select the Switch/Router Checks tab
) and complete the following steps.