Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 698)

646 Brocade Network Advisor IP User Manual
53-1003153-01
Network OS switches in VCS mode
17
Viewing QoS parameters on the Network OS switch port
Table 69 (DCB) and Table 70 (non-DCB) describe the parameters that displays on the View Port
dialog box - QoS tab.
NOTE
Network OS switches with VCS enabled supports only the DCB map. Network OS switches in
standalone mode supports both the DCB and Traffic Class maps.
QoS-DCB
MTU The maximum transmission unit (MTU) in bytes. The value range is from
1522 through 9216 and the default value is 2500.
iSCSI Priority The CoS priority value for iSCSI traffic. The value range is from COS 0
through COS 7 and the default value is COS 4.
TABLE 69 QoS (DCB) parameters on the Network OS switch port.
Field/Component Description
Mode The QoS mode (DCB).
Fabric Remap Priority The fabric remap priority of the port. Valid values are CoS 0 through CoS
6, and the default is CoS 0.
DCB Map The DCB map that is associated with the FCoE Map. This is a read-only
field.
Lossless Remap Priority The FCoE lossless remap priority of the port. Valid values are CoS 0
through CoS 6, and the default is CoS 0.
Precedence This number determines the map’s priority. Valid values are from 1
through 100.
DCB Map Parameters
•
PG ID — Lists the priority group ID (15.0 to 15.7 and 0 to 7).
•
% Bandwidth — Lists the bandwidth value for priority group IDs 0-7.
The total of all priority groups must equal 100%.
•
Priority Flow Control — When enabled, enables priority flow control
on individual priority groups.
•
CoS — Lists the Class of Service (CoS) value that corresponds to the
Priority Group ID rows. The CoS value must be mapped to at least
one of the Priority Group IDs (0-7).
TABLE 68 Port parameters on the Network OS switch port (Continued)
Field/Component Description