Creating a dcb map – Brocade Network Advisor IP User Manual v12.3.0 User Manual
Page 670
618
Brocade Network Advisor IP User Manual
53-1003153-01
QoS configuration
17
Creating a DCB map
The procedure in this section applies only for Fabric OS versions earlier than Fabric OS 7.0.
When you create a DCB map, each of the Class of Service (CoS) options (0-7) must be mapped to
at least one of the Priority Group IDs (0-7) and the total bandwidth percentage must equal 100. All
QoS, DCB map, and Traffic Class map configurations apply to all ports in a LAG.
There can be, at the most, 16 entries in the Priority Group table. Eight of the entries are Strict
Priority entries with a Priority Group ID (15.0-15.7) and eight are user-definable entries with a
Priority Group ID of 0-7. Refer to
for an example of priority group configuration.
NOTE
The 10 Gbps DCB/FC switch module can have only one DCB map.
1. Select Configure > DCB.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select a switch, and click Edit.
3. Click the QoS tab on the Edit Switch dialog box.
The QoS dialog box displays, as shown in
TABLE 61
Priority grouping allocated in a 15-priority group example
Priority group ID
Bandwidth (%)
Priority flow control
0
55
on
1
25
on
2
0
off
3
0
off
4
5
off
5
0
off
6
15
on
7
0
off
15.0-15.7
Strict priority
No bandwidth % configuration
allowed
on