Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 1073)

Brocade Network Advisor IP User Manual 1021
53-1003153-01
VPLS Manager
29
a. From the drop down list, select the Class of Service (COS) you want to assign to this
instance.
b. Enter a Maximum Transmission Unit (MTU) for a VPLS instance. MTU is the size of the
largest data packet that can pass along a device. Determine the range of values you can
enter by checking the configuration guide for your device.
The Peers table shows the peer of the selected device.
c. You can select the IP address of the peer by clicking the drop down arrow for Peer IP
address. By default, the ingress IP address of a tunnel is selected.
d. Enter the maximum number of MAC entries that the VPLS instance is allowed to learn.
Determine the range of values you can enter by checking the configuration guide for your
device.
3. Click Next.
The Port Configuration page displays ( Figure 432 ).
FIGURE 432 VPLS Configuration wizard Port Configuration dialog box
Discovered VPLS port settings appear under Discovered Endpoint Settings.
Configuring endpoint settings
1. From the Port Configuration page of the VPLS Configuration wizard, select a port from the
Interfaces tree and click the Add button under Configured Endpoint Settings.
A row is added to the Configured Endpoint Settings list.
2. Click the empty Tag Mode field and select one of the following:
- Tagged if you want packets transmitted with a specified VLAN ID.
- Untagged if you want any VLAN ID removed before transmitting the packet.
3. If you chose Tagged mode, complete the following steps.