Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 774)

722 Brocade Network Advisor IP User Manual
53-1003153-01
Layer 3 access control list policy
19
1. Click the Networks tab.
FIGURE 282 Network dialog box, Networks tab
2. Review the List of Networks table:
• Name — The user-defined network name.
• Subnet — The IP address of the subnet.
• Mask — The IP address of the mask.
3. Click Close on the Network dialog box.
To finish configuring the ACL, return to one of the above procedures.
Creating a network
You can access the Network dialog box when configuring a standard or extended L3 ACL device
configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:
• “Creating a standard L3 ACL configuration” on page 700
• “Editing a standard L3 ACL configuration” on page 702
• “Copying a standard L3 ACL configuration” on page 703
• “Creating an extended L3 ACL configuration” on page 704
• “Editing an extended L3 ACL configuration” on page 706
• “Copying an extended L3 ACL configuration” on page 707
To create a network, complete the following steps.
1. Click the Networks tab.
2. Click Add.
The Add Network dialog box displays.
FIGURE 283 Add Network dialog box