Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 1145)

Brocade Network Advisor IP User Manual 1093
53-1003153-01
Chapter
33
Deployment Manager
In this chapter
• Introduction to the Deployment Manager . . . . . . . . . . . . . . . . . . . . . . . . 1093
• Editing a deployment configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1093
• Duplicating a deployment configuration . . . . . . . . . . . . . . . . . . . . . . . . . 1094
• Deleting a deployment configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1095
• Deploying a configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1095
• Viewing deployment logs. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1095
• Generating a deployment report . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1095
• Generating a deployment configuration snapshot report. . . . . . . . . . . . 1096
• Searching the configuration snapshots . . . . . . . . . . . . . . . . . . . . . . . . . . 1096
Introduction to the Deployment Manager
The Deployment Manager allows you to view, edit, duplicate, delete, deploy, and generate reports
for the following types of deployment configurations:
• DCB
• VLAN
• STP
• Security
You cannot create configurations using the Deployment Manager. The deployment configurations
must have been previously created and saved. Refer to the following sections for information about
creating these types of configurations:
• “Fibre Channel over Ethernet” on page 597 (for DCB configurations)
• “VLAN Management” on page 949 (for VLAN and STP configurations)
• “Security Management” on page 679
Deployments that were created through the legacy Configuration Wizard are listed in the
Deployment Manager dialog box, but cannot be modified, deployed, or deleted. You can only launch
reports for these deployments.
Editing a deployment configuration
1. Select Configure > Task Scheduler.
The Task Scheduler dialog box displays, as shown in Figure 462 .