Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 714)

662 Brocade Network Advisor IP User Manual
53-1003153-01
Virtual FCoE port configuration
17
FIGURE 261 Virtual FCoE Ports dialog box
3. Select one or more virtual ports from the Ports list.
4. Perform one of the following tasks:
• Click Enable to enable a selected virtual FCoE port from the Virtual FCoE Ports tab.
• Click Disable to disable a selected virtual FCoE port from the Virtual FCoE Ports tab.
• Click Connected Devices to view a list of FCoE virtual ports and to what they are directly
connected.
5. Click Close to close the dialog box.
Clearing a stale entry
A stale entry is a device that logged in and logged off but, because a port went down after an FLOGI
was received, the device failed to receive the message. The entry in the FCoE Connected Devices
table becomes stale and you must clear it manually.
NOTE
Clearing a stale entry is not supported for Network OS devices.
1. Select a virtual FCoE port from the FCoE Configuration dialog box and click Connected Devices.
The Connected Devices dialog box displays.
2. Select one or more rows from the Connected Devices table and click Disconnect.
The DCB Confirmation and Status dialog displays.
The selected connected device should be cleared from the switch cache and from the table.
Note, however, that the connected devices might still be active and this operation could
potentially stop traffic between the connected devices and the switch.
3. Review the changes carefully before you accept them.
4. Click Start to apply the changes, or click Close to abort the operation.