Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 773)

Brocade Network Advisor IP User Manual 721
53-1003153-01
Layer 3 access control list policy
19
14. Click OK on the Advanced Settings dialog box.
To finish configuring the ACL, return to one of the following procedures:
• “Creating an extended L3 ACL configuration” on page 704
• “Editing an extended L3 ACL configuration” on page 706
• “Copying an extended L3 ACL configuration” on page 707
• “Creating an IPv6 L3 ACL configuration” on page 709
• “Editing an IPv6 L3 ACL configuration” on page 711
• “Copying an IPv6 L3 ACL configuration” on page 712
Network configuration
The Management application allows you to filter traffic from a specific Network. A Network is made
up of one or more devices in a subnet. Use the following procedures to configure a network:
• “Viewing existing networks” on page 721
• “Creating a network” on page 722
• “Editing a network” on page 723
• “Copying a network” on page 724
• “Deleting a network” on page 724
Viewing existing networks
You can access the Network dialog box when configuring a standard or extended L3 ACL device
configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:
• “Creating a standard L3 ACL configuration” on page 700
• “Editing a standard L3 ACL configuration” on page 702
• “Copying a standard L3 ACL configuration” on page 703
• “Creating an extended L3 ACL configuration” on page 704
• “Editing an extended L3 ACL configuration” on page 706
• “Copying an extended L3 ACL configuration” on page 707
To view all existing networks, complete the following steps.