Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 783)

Brocade Network Advisor IP User Manual 731
53-1003153-01
Layer 3 access control list policy
19
Viewing existing services
You can access the Service dialog box when configuring an extended L3 ACL device configuration.
To configure an extended L3 ACL, refer to one of the following procedures:
• “Creating an extended L3 ACL configuration” on page 704
• “Editing an extended L3 ACL configuration” on page 706
• “Copying an extended L3 ACL configuration” on page 707
• “Creating an extended L3 ACL configuration” on page 704
• “Editing an IPv6 L3 ACL configuration” on page 711
• “Copying an IPv6 L3 ACL configuration” on page 712
To view all existing services, complete the following steps.
1. Click the Services tab.
FIGURE 286 Service dialog box, Services tab
2. Review the List of Services table:
• Name — The service name.
• Protocol — Whether the service uses the TCP or UDP protocol.
• Port — The port number.
• User-defined — Whether the service is user-defined or not.
3. Click Close on the Network dialog box.
To finish configuring the advanced settings, refer to “Configuring L3 ACL advanced settings” on
page 717.