Deploying a payload configuration, Deleting a payload configuration – Brocade Network Advisor IP User Manual v12.3.0 User Manual
Page 956
904
Brocade Network Advisor IP User Manual
53-1003153-01
Deploying a payload configuration
25
Deploying a payload configuration
Payload configurations are deployed to targets in one of the following ways:
•
On a scheduled basis, if a deployment schedule has been set up for the configuration.
•
On demand, if Save Without Scheduling Deployment is selected in the Deployment Schedule
pane of the Configuration Wizard. Configurations can be manually deployed when required.
“Creating a payload configuration”
on page 895 for more information on setting
up a deployment schedule.
Use the following procedure to deploy the configuration on demand.
1. Select Configure > Configuration Wizard.
2. Select the configuration you want to deploy from the Product Configurations list.
3. Click Deploy.
4. Click Yes in the confirmation message.
The Deployment Status dialog box displays.
NOTE
If a configuration has more than one payload and a failure occurs during deployment of a
payload, the Management application aborts the deployment of that payload, but continues to
deploy the remaining payloads.
5. Click Close when you are finished viewing the information.
Deleting a payload configuration
1. Select Configure > Configuration Wizard.
2. Select the configuration you want to delete from the Product Configurations list.
3. Click Delete.
4. Click Yes in the confirmation message.