Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 1226)

1174 Brocade Network Advisor IP User Manual
53-1003153-01
IP Traffic analyzer monitoring and sFlow reports
34
4. In the Reports list, select VLAN.
The report presents the following information:
• VLAN - The ID of the source and destination VLANs used by the users.
• Ethernet QOS - The 802.1p priority tag configured on the incoming and outgoing traffic.
• Port - The ID of the port on which the traffic is being received and being sent.
• For VCS fabrics, the send and receive ports are from different devices.
• MAC - The source and destination MAC addresses of the traffic and the VM host (Top VM
Talkers reports). If Source and Destination VM Host column values are not related to VM, no
values will display.
• User (802.1X) - The name of the user who originated the traffic and the user who received the
traffic. This name is the ID the client used to gain access to the network.
• Frames - The size of the traffic in frames.
• MBytes - The size of the traffic in megabytes for the time duration shown on the report.
A subtotal is displayed for each of the top users. At the end of the report, a subtotal for the
remaining network users and a total for the entire network are displayed.
Viewing all Layer 3 and Layer 4 traffic
The Layer3/4 All report displays the top users of all Layer 3 and Layer 4 traffic. Complete the
following steps to display the report.
1. Select Monitor > Traffic Analysis > Monitor sFlow.
2. On the Monitor sFlow dialog box, choose one of the following options:
• To view a report for a device group, click the report icon for the device group you want.
• To view a report for a device, click the name of the device group to which the device
belongs, and on the Device list page, click the report icon for the device.
3. In the Category list, select L3/L4 Reports.
4. In the Report list, select All.
The report you see is similar to the one shown in Other Layer 3/Layer4 Talkers. (Refer to “Viewing
other Layer 3 or Layer 4 Top Talkers” on page 1180.)
Viewing all IPv4 Layer 3 or Layer 4 Top Talkers
The IPV4 Top Layer 3/4 Top Talkers report shows the top users of all Layer 3 and Layer 4 services
on IPv4 traffic. Complete the following steps to display the report.
1. Select Monitor > Traffic Analysis > Monitor sFlow.
2. On the Monitor sFlow dialog box, choose one of the following options:
• To view a report for a device group, click the report icon for the device group you want.
• To view a report for a device, click the name of the device group to which the device
belongs, and on the Device list page, click the report icon for the device.
3. In the Category list, select L3/L4 Reports.
4. In the Report list, select IPv4.