Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 964)

912 Brocade Network Advisor IP User Manual
53-1003153-01
Changing product credentials
26
11. Click OK.
The Deployment Status dialog box displays, which allows you to view the progress and status of
the deployment.
Click Abort to stop the deployment.
NOTE
The abort action does not stop the tasks that have already started.
When deployment is complete, click Report to view the CLI Deployments Report.
12. Click Close to close the Deployment Status dialog box.
NOTE
Closing the Deployment Status dialog box does not stop deployment.
To check the results of the deployment in the Product CLI Report, refer to “CLI deployment
reports” on page 930. For details about valid and invalid responses when you deploy a
configuration, refer to “Valid and invalid responses from devices” on page 918.
Changing product credentials
Passwords required to access the device must be entered for the device.
1. Click Change Template Credentials on the Definition tab of the CLI Template dialog box.
The CLI Template dialog box displays.
NOTE
If you selected the Use User CLI Credential check box in the Policy tab of the Users dialog box
(refer to
“Password policies” on page 207) and you configured credentials in your User Profile
(refer to “Configuring CLI credentials” on page 214), the Management application only uses
those credentials to access the device.
NOTE
Entering a password is not required if the password required to access the device is already
entered during discovery or configured in your user profile.
FIGURE 368 CLI Credentials dialog box