Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 1520)

1468 Brocade Network Advisor IP User Manual
53-1003153-01
IP device properties
E
FC Ports properties
•
Identifier — The identifier of the port.
•
Name — The name of the port. This is an editable field. Enter a
name (up to 64 characters) for the port.
•
WWN — The world wide name of the device.
•
FC Address — The Fibre Channel address. Each FC port has both an
address identifier and a world wide name.
•
Status — The operational status.
•
Additional Info — Additional information about the port.
•
Calculated Status — The calculated operational status. There are
four possible operation status values (Up, Down, Disabled, or
Backup Active).
•
State — The state for the port.
•
Blocked — The configuration of the switch (blocked or unblocked).
•
Type — The port type.
•
Locked Type — The port type of the locked product.
NOTE: Offline ports of a Network OS device in AG mode are
displayed as N_Port.
•
Speed (Gbps) — The speed of the port.
•
Buffers Desired — The number of buffers desired but not allocated.
•
Buffers Allocated — The number of buffers allocated.
•
Distance Actual (km) — The actual distance (in km) for end port
connectivity.
•
Distance Estimated (km) — The estimated distance (in km) for end
port connectivity.
•
Distance setting — Whether the connection is considered to be
normal or longer distance.
•
Attached Switch — The IP address of the attached device.
•
Attached Port # — The port number of the attached product.
•
Connected Devices — The WWN for each connected device.
•
NPIV Status — Whether NPIV is enabled or disabled on the port.
•
Flex Port — Whether Flex is supported on the port.
•
Forward Error Correction (FEC) — Whether FEC is enabled or
disabled.
TABLE 143 VCS fabric properties (Continued)
Field/Component Description