Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 1511)

Brocade Network Advisor IP User Manual 1459
53-1003153-01
IP device properties
E
FDMI Driver version The FDMI driver version.
FDMI Manufacturer The manufacturer of the FDMI.
Location The physical location of the product.
Contact The name of the person or group you should contact about the product.
Description The description of the product.
Connected AP count Number of APs connected to the controller or switch.
Managed AP count Only applicable to the selected controller. Number of APs that the
selected controller manages.
Controller cluster mode Only applicable to the selected controller. Cluster mode of the controller:
Active, Standby and None.
Controller cluster name Only applicable to the selected controller. Cluster name.
Controller cluster members Only applicable to the selected controller. IP addresses of the controller
cluster peers.
Cluster (MCT switches only) The cluster details of the Multi-Chassis Trunk (MCT) switch. MCT cluster
details include:
•
Cluster ID — The MCT cluster ID.
•
Cluster Name — The MCT cluster name.
•
Cluster RBridge ID — The RBridge ID of the MCT cluster.
•
Cluster State — Whether the MCT cluster is deployed or undeployed.
•
Isolation Mode — Whether isolation mode is loose or strict.
•
Active Member VLAN Range — The active member VLAN for data.
•
Configure Member VLAN Range — The configured member VLAN for
data.
•
Keep Alive VLAN — An alternate VLAN for Cluster Communication
Protocol (CCP) when the Inter-Chassis Link (ICL) is down.
•
Session VLAN — The VLAN used by the cluster for control
operations.
•
ICL Name — The ICL name.
Cluster Peer (MCT switches only) The cluster peer details of the MCT switch. MCT cluster peer details
include:
•
Peer Product — The name and IP address of the MCT peer product.
•
Peer IP Address — The VE interface IP address of the MCT peer.
•
Peer RBridge ID — The RBridge ID of the MCT peer.
•
ICL Name — The name of the ICL used to reach the MCT peer.
•
Keep Alive Interval — The interval time for CCP over the keep-alive
VLAN.
•
Hold Time — The hold-time before making the CCP down state when
the ICL goes down.
•
Fast Failover — Whether fast failover is enabled or disabled.
•
Active VLAN Range — The active member VLAN for data.
•
Peer State — Whether the peer state is CCP up or CCP down.
•
Peer State Up Time — How long the peer has been up.
•
Peer State Down Reason — The reason the peer is down.
Add button Click to add a user-defined property. For more information, refer to
“Adding a property field” on page 1473.
Edit button Click to edit a user-defined property. For more information, refer to
“Editing a property field” on page 1473.
TABLE 142 IP device and port properties (Continued)
Field/Component Description