Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 1308)

1256 Brocade Network Advisor IP User Manual
53-1003153-01
Configuration rules
37
The contents of the backup configuration file display in the CLI Configuration File text box.
Select the lines you want to use in the CLI Configuration File text box and click the right
arrow to move the lines to the Configuration text box.
9. Check the Use regular expressions check box to enter a regular expression in the Configuration
text box.
10. Select one of the following options to determine whether the configuration lines should match
or not match from Configuration the lines below list:
• Matches — Select this option from the list if you want the configuration line to match the
line in the device configuration file.
• Not Matches — Select this option from the list if you do not want the configuration line to
match the line in the device configuration file.
11. Enter one or more configuration lines with which you want to compare the device configuration
in the Configuration text box.
12. Select the Lines in exact order check box to match the configuration lines in the same order in
the Configuration text box as the device configuration.
Clear the Lines in exact order check box to search and match each configuration line in the
Configuration text box.
13. Enter details to correct the failure, if the condition fails, in the Remediation text box.
Remediation content displays in the Configuration Rule Report for each failed condition. The
remediation detail cannot be over 1024 ASCII characters.
14. Click OK on the Add Condition dialog box.
15. Click OK on the Add Configuration Rule dialog box.
16. Click OK on the Add Monitor dialog box.
The updated configuration policy manager displays in the Monitors table of the Configuration
Policy Manager dialog box.
17. Click Close on the Configuration Policy Manager dialog box.
Selecting a product
You can only select one product at a time.
1. From the Add Condition dialog box, click the Product ellipsis button to select a product.
The Select Product dialog box displays.
2. Select a product from the Available Products list, and click the right arrow button to move the
product to the Selected Product table.
The Available Products list contains the same fields as the IP Product list (refer to “IP Product
List” on page 392).
3. To remove a product from the Selected Product list, select the product and click the left arrow
button to move the product to the Available Products list.
The Selected Product list contains the same fields as the IP Product list (refer to “IP Product
List” on page 392).
4. Click OK on the Select Product dialog box.