Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 1054)

1002 Brocade Network Advisor IP User Manual
53-1003153-01
VLL manager
29
• All peers are up.
• All peers are down.
• Some peers are down.
• VCID - The VCID of the VLL.
Endpoint Settings display the following information about the A Endpoint and Z Endpoint of the
selected VLL in the fields below:
• Name - The endpoint device name and IP address.
• COS - Class of Service associated with the endpoint.
• VLL Mode -
• Tagged: A VLAN ID tag is added to the packets on the ingress router. When the packet
arrives at the egress router, the tag is stripped off and the packet is forwarded.
• Raw: The ingress router does not add a VLAN ID to the packets.
• Tag Mode -
• Tagged: If the endpoint is a tagged port, the device transmits the packet with the specified
VLAN ID and forwards it out the specified interface.
• Untagged: If the endpoint is an untagged port, the device removes any VLAN ID before
transmitting it out the specified interface.
• L2 Status - Layer 2 status (Up or Down).
• Outer VLAN ID - Present if the Tag Mode for the endpoint is Tagged. The service provider
end point tag.
• Inner VLAN ID - Present if the Tag Mode for the endpoint is Tagged. The customer end point
tag.
8. Right click any entry in the table to display the Print pop up menu. Select Print from the menu
to print the table.
Viewing Saved VLL configurations
To view current saved VLL configurations, do the following:
1. Select Configure > MPLS > VLL.
2. Select the Saved Configurations tab ( Figure 417 ).