Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 1071)

Brocade Network Advisor IP User Manual 1019
53-1003153-01
VPLS Manager
29
• PE Products table — Displays the following information:
 PE Devices — Names and IP addresses of the endpoint devices.
 Peers Up — The number of peers that are up.
 Endpoints Up — The number of endpoints that are up.
• Endpoints table — Displays the following information:
 Endpoints — Names and IP addresses of the endpoint devices.
 Tag Mode — Tagged if a VLAN tag is used. Untagged if a VLAN tag is not used.
 Outer VLAN ID — Present if the Tag Mode for the endpoint is Tagged. The service
provider end point tag.
 Inner VLAN ID — Present if the Tag Mode for the endpoint is Tagged. The customer end
point tag.
 L2 Status — Displays whether L2 is up or down.
5. Right-click any entry in the table to display the Print pop up menu. Select Print from the menu
to print the table.
6. Click Close to close the VPLS Manager dialog box.
Adding or editing a VPLS instance
To add a VPLS Instance, do the following.
1. From the Saved Configurations tab of the VPLS Manager, click the Add button.
The Target Selector dialog box of the VPLS configuration wizard displays ( Figure 430 ).
FIGURE 430 VPLS Configuration wizard Target Selector dialog box
2. Enter a name for the VPLS. The name must be unique on each device and cannot contain
spaces, asterisks (*), or question marks (?).
3. If you want to use a specific VCID, enter the VCID. If you do not specify a VCID, the next
available VCID in the VCID pool is assigned.