Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 1198)

1146 Brocade Network Advisor IP User Manual
53-1003153-01
IP Custom performance reports
34
5. To schedule the report to run at a specific time, click the Time Settings tab.
FIGURE 486 Add/Edit Report Definition dialog box - Time Settings tab
You can choose from the following settings:
• Relative Time - Enables you to select a time range relative to the present for the display of
historical data. The choices are incremental from the last 30 minutes to the last 24 hours.
• Absolute Time - Enables you to get a snapshot of data from a specific time range, as
specified by the Start Date, Start Time, End Date, and End Time parameters.
Data collected for the report comes from data sampled at different granularities depending on
your time setting as shown in
Table 97 .
TABLE 97 Granularity of data collected for time settings
Time Settings Sampling Granularity
Less than or equal to 12 hours Real-time or “raw”
Less than or equal to 1 week 30 minutes
Less than or equal to 30 days 2 hours
Up to 2 years 1 day