Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 1228)

1176 Brocade Network Advisor IP User Manual
53-1003153-01
IP Traffic analyzer monitoring and sFlow reports
34
4. In the Reports list, select IPV4.
5. In the next list, select TCP.
The report shows the following information:
• IPV4
- Source - The source IP addresses of the IPv4 traffic. If enabled, host names of the IP
address are shown in parentheses.
- Destination - The destination IP addresses of the IPv4 traffic. If enabled, host names of the
IP address are shown in parentheses.
- TOS/DSCP - The TOS bit value or the Differentiated Services Code Points (DSCP) value in
the packets.
• Port - For VCS fabrics, the send and receive ports are from different devices.
- In - The ID of the port on which the traffic is being received.
- Out - The ID of the port on which the traffic is being sent.
• TCP
- Src Port - ID of the port on which the TCP packet originated. The value shown in this
column can be one of the following values:
 ID of the well-known port.
 The term “various”, if the value is greater than 1023 (threshold for well-known ports)
and if the port number on the other side of the connection is an ephemeral port.
- Dest Port - ID of the port on which the TCP packet was received. The value shown in this
column can be one of the following values:
 ID of the well-known port.
 The term “various”, if the value is greater than 1023 (threshold for well-known ports)
and if the port number on the other side of the connection is an ephemeral port.
• User (802.1X)
- Name of the user who originated the traffic. This name is the ID the client used to gain
access to the network.
- Name of the user who received the traffic. This name is the ID the client used to gain
access to the network.
• Frames - Size of the traffic in frames.
• Mbytes - Size of the traffic in megabytes for the time duration shown on the report.
A subtotal is displayed for each of the top users. This subtotal is displayed by source and
destination IP addresses. If the report is for a device group, the name and IP address of the device
that the traffic accessed appear in parentheses. If the report is for an individual device, only the
source and destination IP addresses appear.
At the end of the report, a subtotal for the remaining network users and a total for the entire
network are displayed.